MINIFLEX NOW SUPPORTS EFM TECHNOLOGY
Are proud to be distributors and partners of FlexDSL Telecommunications AG
WE ARE BIG ENOUGH TO COMPETE – BUT SMALL ENOUGH TO CARE!
FlexcomONE SFP Copper Wire ModemThe new FlexcomONE is a single pair, low power SFP (Small Form-factor Pluggable) Ethernet copper wire modem using the transmission friendly Pulse Amplitude Modulation (PAM) technology. The modem is optimized for a duplex 10Mbps connection speed over a pair of copper wires up to 2000 meters without the need of configuration. The FlexcomONE can be plugged into any Ethernet device with SFP ports that support 100BASE-FX. |
GigaFlex SHDSLThe FlexDSL GigaFlex universal transmission system was developed for mission-critical applications such as SCADA (Supervisory Control and Data Acquisition) or Telecontrol Networks.
|
MiniFlex FlatRack for 5 Linecards with integrated SwitchThe 5-slot FlexDSL MiniFlex FlatRack is designed for a 19” rack and has a height close to 1/2U (24mm). This allows to occupy only 1U (43.6mm) in the rack together with cooling space.
|
MiniFlex SHDSL EFMThe MiniFlex EFM-based SHDSL.bis product family were especially designed for the applications where the compatibility with third-party equipment should be maintained. The MiniFlex EFM-based products can operate with the similar peer, with the GigaFlex SHDSL or with a third-party EFM-based DSLAM or MSAN. The ITU-T 991.2 (G.shdsl) and IEEE 802.3 standards are supported. MF-EFM-SRxL-2Eth,V1 Line Card for various MiniFlex Racks is available too. |
Ethernet over E1 & TDMoIP Unit and CardMiniFlex E1 Dinrail unit allows, depending on an installed Firmware, either Ethernet data transmission over E1 links or E1 channels transmission over Packet Networks.
|
FlexCON & MiniFlex VoIP GatewaysThe brand-new FlexCON & MiniFlex VoIP gateways allows voice (FXS, FXO, VF) and Serial (RS-232/RS-485) data transmission over packet networks.
|